Wing Root Fairing

	THE PRODUCTS NEEDED FOR THE JOB ARE LAMINATING EPOXY RESIN WITH HARDENER AND SUPER LIGHTWEIGHT FAIRING COMPOUND AND PROTECTIVE GLOVES. MASK THE WING WITH POLYTHENE SHEETING GLUE LOWER LIGHT PLY PLATFORM IN PLACE WITH CYNO ACRILIC
MIX EPOXY RESIN WITH HARDENER FOLLOWING THE INSTRUCTIONS ON THE CONTAINER BRUSH ON A THIN COAT OF ACTIVATED EPOXY RESIN OVER THE ENTIRE AREA THIS WILL HELP TO BOND THE MIXTURE OF FAIRING COMPOUND ONTO THE WOOD STIR IN THE SUPER LIGHTWEIGHT FAIRING COMPOUND UNTIL THE MIXTURE SUPPORTS THE SPATULA UP RIGHT
	APPLY THE FAIRING PUTTY TO THE THE WING AND FUSELAGE USING A SPATULA WORK THE PUTTY INTO THE LOWER PLATFORM
WITH A SPATULA OR A ROUNDED PIECE OF CARD SMOOTH OVER THE PUTTY REMOVE WITH A SPATULA ANY EXCESS PUTTY
Finally Support the model so that the fairing stays level and does not "Flow" while it hardens.