| Release Agent |
Release Agent
system.
Formula Five Clean ‘N’ Glaze (Step 1)
0.95 litre
£14.00
Cleaning
and polishing cream, Clean ‘N’ Glaze
The
combination of Clean ‘N’ Glaze and Mould release wax yields high-gloss GRP
mould surfaces for the optimal demoulding.Clean
‘N’ Glaze is applied with a soft cotton cloth and polished to a gloss then
the Mould Release Wax is applied as the next step.
Mould surface.
The mould should be completely dry, clean and free to the maximum possible
extent of any residue caused by other release agents. All Formula Five
products are suitable only for sealed surfaces, e.g. GRP (mould resins, gel
coats, etc.) Porous surfaces, eg. Wood or stone must be sealed.
Application
A thin coat of the Clean ‘N’ Glaze product is applied to the surface in a
circular motion with a soft cotton cloth. Apply to a surface of only about
0.5m² per working cycle, and wipe off any excess with a clean, dry cloth.
Then polish to a high gloss by hand or with a soft-quality buffing wheel. If
the glossy surface should still exhibit some slight residue, this can
removed by hand with a moist cotton cloth. After the polishing process
Formula five Mould Release Wax is applied to the surface of the mould in
accordance with the instructions. An occasional, repeated application of
Formula Five Clean ‘N’ Glaze makes sure that demoulding takes place without
problems.
Formula Five Mould Release Wax (step 2)
340g
Tin £16.00
A thin coat
of the Mould Release Wax is applied in circular motion with a soft cotton
cloth to the surface prepared previously with Formula Five Clean ‘N’ Glaze.
After a short drying time (approx. 10-12 minutes after being applied), the
surface is polished with a dry, clean cotton cloth.
Please bear
in mind that if it is too easy to polish away the wax film, then you have
not waited long enough! It is imperative that the drying time is strictly
observed. The mould surface is polished until it adopts a uniform high gloss
free of filming. Before demoulding for the first time, new moulds are
pre-treated with two to three coats of Formula Five Mould Release Wax. Each
coat should be applied with a different set of polishing movements (e.g. top
to bottom, left to right, circular motion). After each demoulding process, a
fresh coat of Formula Five mould release wax is applied until the moulds are
well incorporated. Later, several demoulding are possible with the one
application of release agent. Wait at least an hour after applying the last
wax coat before you start demoulding. |
|
